06 civic aftermarket sound

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=90562
Printed Date: May 09, 2025 at 11:18 AM

Topic: 06 civic aftermarket sound

Posted By: gus738
Subject: 06 civic aftermarket sound
Date Posted: February 16, 2007 at 9:05 PM

hey everyone well i hope i can get some help i have a 2006 honda civic 2dr couple EX, it has the preimum sound w/out navi 7skrs 8'' sub pakage , it has the stock amp ...... and that pos is causing me trouble or im looking at it too hard. I want to upgrade to aftermarket sound i bought the scosche dash kit HA1561ETB it came with the HA10B harness and the HAAB antenna adaptor . and i read the back of it and it says that "not for use on "factory amplified" sound systems. i dont know where to start i dont care about cutting wires so insted of using stock wiring i dont mind putting new wires for speaker wire to amps so the only cutting i would do on the stock harness to match the power / ground remote lead on the aftermarket stereo right? please give your input thanks this is my set up.

PIONEER AVIC-N3 kicker ks 6-1/2 kicker dual L5s kicker zx850.4 kicker zx1500.1 kicker O guage kit kicker 4 channel si45 rca cables ....

Replies:

Posted By: stevdart
Date Posted: February 16, 2007 at 10:45 PM

Well, I would say basically that you remove all of the OEM stuff. Then you use the harness to attach your new deck to the factory wiring.

Or did I misunderstand your question?

-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.

Posted By: gus738
Date Posted: February 16, 2007 at 10:50 PM

that harness clearly says not for preimum amplified sound , basicly my car has a stock amp and im trying to figure out how to properly connect all aftermarket products and i know in this website their has to be someone that installed/ has a car that has aftermarket that went thro this process or atlest knows my answer.... and yes i think i would of relieased that just to remove stock deck spkrs etc etc and just put new stereo with harness lol but i dont htink its that easy .

Posted By: gus738
Date Posted: February 17, 2007 at 1:32 AM

any more thoughts guys? should i just run new speaker wire from aftermarket speakrs to my amp then on my stereo just connect remote led illuminator ground?

Posted By: gus738
Date Posted: February 19, 2007 at 5:25 PM

57 reads only 1 reply posted_image no stock harness can be used since i dont know which one i need cuz the one i got wont work on my amplified sound so i need to know whats the best way of connecting my sound for quality?