Print Page | Close Window

component speaker wiring

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91023
Printed Date: May 14, 2024 at 7:00 PM


Topic: component speaker wiring

Posted By: aknavy
Subject: component speaker wiring
Date Posted: February 26, 2007 at 4:01 PM

I've got a set components that I want to run off of one channel. Typical set - 2 6.5, tweeter, and crossover. They're rated at 3 ohms per speaker set. How do I wire these so that they're running off of one channel? Amp is 1 ohm stable. Thanks.




Replies:

Posted By: DYohn
Date Posted: February 26, 2007 at 4:21 PM
Amp-to-crossover, crossover-to-speakers

-------------
Support the12volt.com



Posted By: haemphyst
Date Posted: February 26, 2007 at 5:36 PM
DYohn] wrote:
Amp-to-crossover, crossover-to-speakers

Repeat with other set, connected to the same amplifier channel.

-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."


Print Page | Close Window