kenwood kac 9152d

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91912
Printed Date: May 13, 2025 at 11:29 AM

Topic: kenwood kac 9152d

Posted By: drastikkreation
Subject: kenwood kac 9152d
Date Posted: March 20, 2007 at 5:31 PM

I have 2 audiobahn aw-1200n 12" subs and a kenwood kac-9152d class d mono amp. i know that the subs and the amp are 1 ohm stable. How can do i wire them to get the best sound possible.

Dont laugh at the brands i have a jeep wrangler and i did not want to spend alot of money because of the theft factor.

Replies:

Posted By: aznboi3644
Date Posted: March 20, 2007 at 5:36 PM

What impedance are the subs???

Use the online calculator

here

Posted By: drastikkreation
Date Posted: March 20, 2007 at 5:49 PM

4 ohm dvc

Posted By: aznboi3644
Date Posted: March 20, 2007 at 5:56 PM

Than wire it parallel parallel like in the calculator

Posted By: drastikkreation
Date Posted: March 21, 2007 at 4:19 PM

ok i have done that. now when i connect to the amp do i bridge the speaker wire or do i connect on the same side

Posted By: aznboi3644
Date Posted: March 21, 2007 at 5:03 PM

The amp CANNOT be bridged...just wire all positives to postives and all negatives to negatives

Posted By: loosingmymind
Date Posted: March 22, 2007 at 9:31 PM

I used to sell the 9152d at my shop and despite the literature; that amp hates to be run at 1 ohm! Won't last long like that.

Dave

Print Page | Close Window