Print Page | Close Window

how to bridge old lanzar opti 200?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=94070
Printed Date: May 10, 2025 at 12:29 PM


Topic: how to bridge old lanzar opti 200?

Posted By: obsessiveracer
Subject: how to bridge old lanzar opti 200?
Date Posted: May 19, 2007 at 11:11 PM

i have an old lanzar opti 200 and i want ot know how to bridge it also the terminals are not on the side of the amp so i have wires soldered directly to the board do i use both positves or one negative left positive right negative...any help would be much apreciated. this is an old lanzar amp from around 1999 or so


-------------
Play It Till It Hertz, Bag it then drag it



Replies:

Posted By: still_walkin
Date Posted: May 26, 2007 at 12:23 AM
the only way to bridge a 2 channel amp correctly is to take  the two outer  positve/negitvie posts ant use them ONLY. example your amp has (left channel) + - and (right channel)+ - take the left positvie and the right  niegitive and you should be ok but make sure your subs are wire correctly and are ohms match up

-------------
1993 sdv
Alpine 4x6 6x9 5 1/4 swr-10d4
alpine v60
12.5 VGA flip down
Nettop pc w/10" touch screen
78nova
5-re audio 5x7 ,10" sub &
Xtx-500.5
"Take the faceplate off get the jumperpack"


Print Page | Close Window