bridging 2 amps together

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95134
Printed Date: May 14, 2025 at 8:30 AM

Topic: bridging 2 amps together

Posted By: chris89127
Subject: bridging 2 amps together
Date Posted: June 26, 2007 at 12:12 PM

i have 2 pyle driver plad3300d mono block they have a bridged mode but it says put 1 amp on master then 1 on slave then on the speaker terminals the neg wires to the other neg on amp so the 2 amps neg are together then both positive hooks up to sub is that right?

Replies:

Posted By: slab42
Date Posted: June 26, 2007 at 2:44 PM

It seems you already read the manual... hook it up like it tells you to...

Posted By: still_walkin
Date Posted: June 28, 2007 at 12:30 AM

yeah it should work ok i agree

-------------
1993 sdv
Alpine 4x6 6x9 5 1/4 swr-10d4
alpine v60
12.5 VGA flip down
Nettop pc w/10" touch screen
78nova
5-re audio 5x7 ,10" sub &
Xtx-500.5
"Take the faceplate off get the jumperpack"

Posted By: wajih
Date Posted: June 29, 2007 at 6:52 AM

yeah you gotta have a negative wire going to two (-ve)terminals of both amps. Some people like to refer it to as a "Common ground".

But 2 amps dude. Crank tha doodie!!! posted_image

-------------
Ws

Print Page | Close Window