4 ohm dvc sub, pg 300.1, but two terminal
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=95844
Printed Date: July 13, 2025 at 1:35 PM
Topic: 4 ohm dvc sub, pg 300.1, but two terminal
Posted By: cucamelsmd15
Subject: 4 ohm dvc sub, pg 300.1, but two terminal
Date Posted: July 23, 2007 at 4:26 PM
Ok, Im wiring up my new sub/amp combo, and the sub is a PG RSD10d, which has 2x 4 ohm voice coils. The amp is a PG 300.1RSd, but despite being a mono amp, it has 2 sets of outputs. Do I use one set and wire the positive to both VC's, or wire the individual positives to the individual VC's? Im looking for 2 ohm load here.
Replies:
Posted By: haemphyst
Date Posted: July 23, 2007 at 4:44 PM
It's a mono amp. One channel. The terminals are "duplicated" to provide a convenient method of connecting more than one voice coil or woofer.
Wire one coil to each set, or wire the voice coils in parallel AT the woofer, then use one set on the amp... either way, you're done.
-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."
|