is this setup a match?
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=96267
Printed Date: May 20, 2024 at 9:36 PM
Topic: is this setup a match?
Posted By: onsatmex5
Subject: is this setup a match?
Date Posted: August 08, 2007 at 8:32 PM
Will this be enough power to properly run this setup?
KICKER ZX1000.1 1000 W. MONO AMP, Pushing 2 kicker 10 inch L7's in a vented enclosure?
Replies:
Posted By: jeffchilcott
Date Posted: August 08, 2007 at 9:12 PM
RMS power of the L7 10's are 750 each, the ZX1500.1 would be a better match, but the ZX1000 will work just fine. Make sure you buy the correct impedance woofers to match the 2ohm minimum load the ZX amps like.
-------------
2009 0-1000 Trunk WR 154.0DB 2009 1001+ Trunk WR
2007 USACI World Champion
2007 World Record
2006 USACI Finals 2nd Place
Posted By: onsatmex5
Date Posted: August 09, 2007 at 4:09 PM
I have 2 of these subs in a vented enclosure,
https://caraudiosecurity.com/shop/product/products_id/2562.html
RMS Power Range (Watts) 75-600 , The ones I have are the older ones, Can I run them @ 2ohm's using the KICKER ZX1000.1 , I am a little confused!
It says, In addition, each coil may be connected to a different amplifier channel and each channel will see a 2 ohm load.
|