Print Page | Close Window

pg rsd 1200.1, 2, jl w3v2

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97173
Printed Date: July 04, 2025 at 6:58 AM


Topic: pg rsd 1200.1, 2, jl w3v2

Posted By: sri3850341
Subject: pg rsd 1200.1, 2, jl w3v2
Date Posted: September 16, 2007 at 3:24 PM

at a two ohm load the phoenix gold produces 1000 watts the jl audio w3v2
rms value is 300 rms so obviously 2 jl w3v2's would pull 600 rms would the phoenix gold produce to much power for the w3's or will it work overpowering them by 400 watts for the pair??????also looking at slotted
enclosure 1.7 per side with .85 slot will this produce enough sub to match 2 sets of infinity kappa components and kappa 6 x 9's running off of alpine f450??



Replies:

Posted By: jvillefinest
Date Posted: September 17, 2007 at 10:24 AM

depending on what ohm configuration you have on those subs you could add another sub and get a 1.666 ohm load to show your amp. also depends on if that amp is 1 ohm stable. if not then you are just going to have to be easy on the gain and tune it properly or run the chance of the subs going out.

as far as being enough for the kappas...depends on how good you are at tuning.. ;)



-------------
2007 Acura TSX
SQ setup in the works


Print Page | Close Window