2004 dodge intrepid stereo wiring
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=97375
Printed Date: May 12, 2024 at 3:36 PM
Topic: 2004 dodge intrepid stereo wiring
Posted By: littlejeepr
Subject: 2004 dodge intrepid stereo wiring
Date Posted: September 23, 2007 at 9:46 PM
I have everything i need to put my amp and subs in the car except the wireing diagram for the factory stereo, Can someone post the wiring diagram for the stero so i can know what wire does what . Thanks
Replies:
Posted By: zacdavis
Date Posted: September 23, 2007 at 10:17 PM
Do yourself a favor n buy an aftermarket harness and just match up the colors.
Posted By: littlejeepr
Date Posted: September 23, 2007 at 10:20 PM
I'm keeping the factory unit. If i wasn't keeping it I would have bought the harness plug. I just need to know what wires are what for the high frequency converter, to connect to.
Posted By: zacdavis
Date Posted: September 23, 2007 at 10:36 PM
Whats a high frequency converter? Hmm, anywho, I'm guessing your adding subs to the factory system and your looking for a high level signal for the amplifier. I would get it from the 6x9's. Go to the fuse panel for a remote wire. If your having trouble finding the correct fuse to tap into, use a test light. If it comes on when and only when the key is in the on position(or crank) you've found a switched ign. Tap into that for your remote wire. Sometimes its easier to just read the little panel, use the fuse thats for the radio, or another accessory in the vehicle that only works when the ign is on.
Oh, your amp, not sure if your using one that has high level inputs, if it doesnt have them, you will need to buy a "high to low level" adapter. This will create an RCA level input for your amp. It connects to your rear speakers.
|