amp, sub set up

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=98477
Printed Date: May 01, 2024 at 1:04 PM

Topic: amp, sub set up

Posted By: ut_baseball_30
Subject: amp, sub set up
Date Posted: October 30, 2007 at 10:44 PM

i've got a kenwood 9102d mono amp with 850 watts RMS @ 2 ohms. and i have 2 ten inch audiobahn flame excursion subs, both 4 ohm, they're RMS rating is 450 apiece in a ported box. i know the correct wiring diagram would look like this... posted_image

but the amp has 4 speaker outputs, labeled ++--, my question is, do i just use one speaker wire only connecting it to one set of the outputs, or do i use two wires connected to both speaker outputs and have the wiring diagram look something like this...
posted_image

someone please let me know, thanks alot!!

-------------
posted_image

Replies:

Posted By: rudydapimp
Date Posted: October 30, 2007 at 10:46 PM

the amp is internally bridged. they just give you the other set of terminals to aid in wiring.just one set of wires connected to both subs and one terminal will be good

Posted By: ut_baseball_30
Date Posted: October 30, 2007 at 10:53 PM

do u think it matters if a particular + terminal goes with a particular - terminal, or just any + and any -?

-------------
posted_image

Posted By: aznboi3644
Date Posted: October 30, 2007 at 11:14 PM

doesn't matter...theres just two sets for ease of wiring multiple woofers

Posted By: ut_baseball_30
Date Posted: October 30, 2007 at 11:20 PM

cool, thanks a lot guys!

-------------
posted_image