Greetings all. After several years I finally got started with my install
Here's my gear...
(1) Alpine CDA-7995 headunit
(2) 5.25" Infinity Kappa 50.5cs's
(2) 1" Infinity Kappa dome tweeters
(2) Infinity external passive crossovers
(2) 5x7" Infinity Kappa 572.5cf's
(2) Kenwood KAC-649S amps
- 1 KAC runs the front 2 Infinity's (plus tweeters) at 80x2@4ohms
- 1 KAC runs the rear 2 Infinity's at 80x2@4ohms
(2) Rockford Fosgate RFD2112 Punch HX2's
(1) Rockford Fosgate Power 1000bd mono amp running the HX2's at 1000x1@2ohms
(1) Sealed enclosure (dual chamber) at 1.25 cu.ft. per chamber
(1) Rockford Fosgate 1-farad cap
I just finished making the amp rack. I'll post some pics as soon as I resize them
-------------
Squirrel
"No more Cpt. Kirk chit chat"
If its too loud, then you're too old
Donate to the12volt.com
Ok, here's some pics of the amp rack. Sorry if they seem grainy, they didn't resize well and you can't fit much into 30kb lol...
I'm running dual lengths of 4awg for power (not shown). From the fused distro they are split into one 4awg for the RF 1000bd and two 8awg feeds (one for each of the Kenwoods).
Right now my favorite touch has been the cable ties. I wanted something other than a plain plastic zip-tie, so I used the sheathing from some spare 8awg wire and ran the tie through it. Gave it a much better look.
Hopefully I'll have some more to show next weekend.
-------------
Squirrel
"No more Cpt. Kirk chit chat"
If its too loud, then you're too old
Donate to the12volt.com