brake light integrated turn signals

Printed From: the12volt.com
Forum Name: Motorcycle Electronics
Forum Discription: Installing Stereos, Alarms, Remote Starters, Lights, Garage Door Openers and other electronics on motorcycles.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=121024
Printed Date: May 02, 2025 at 12:26 PM

Topic: brake light integrated turn signals

Posted By: fzr600
Subject: brake light integrated turn signals
Date Posted: March 28, 2010 at 4:55 PM

Hey everyone I am trying to find out how I can integrate my turn signals into the brake light on my '94 Yamaha FZR600. The stock brake light has 2 dual filament bulbs so it should be possible. I would like to keep the running lights/brake lights as they are but also have the turn signals integrated into them. Let me know if you have any suggestions on how I can accomplish this. I read that a trailer light converter can be used but this causes the blinkers to flash way too fast when the brakes and the turn signals are applied at the same time.

Brake Light Diagram

Thanks,

Garret

Replies:

Posted By: oldspark
Date Posted: March 28, 2010 at 7:17 PM

Are the dual filament bulbs are 21/3W or similar - ie, they are not BOTH high power filaments (eg 21W)?
(If so, I don't see how being dual filament makes it easier since flash & stop use high-power bulbs, not low power park lights etc.)

Posted By: i am an idiot
Date Posted: March 28, 2010 at 8:25 PM

It will take 4 relays to pull this off/ Do you have room for that?

Posted By: badassrx-7
Date Posted: December 22, 2010 at 12:05 AM

i did this to my 05 zzr. if you go get a hopkins tail light converter "48845" and wire it up so the inputs are all to the right stock wires and the outs are to the left and right tail light bulbs it will do what you want. and the adapter is like 10-15$