Motorcycle Alarm

Printed From: the12volt.com
Forum Name: Motorcycle Electronics
Forum Discription: Installing Stereos, Alarms, Remote Starters, Lights, Garage Door Openers and other electronics on motorcycles.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=53701
Printed Date: May 12, 2025 at 10:43 PM

Topic: Motorcycle Alarm

Posted By: EEZA
Subject: Motorcycle Alarm
Date Posted: April 11, 2005 at 11:09 AM

Hello Guys, very quick question, does anyone have a PDF (or any other format) document that shows the wiring on a Yamaha XJ600N Motorcycle. I have a nice cheap alarm and fitting is not an issue just I would rather search for the necessary wires without first blindfolding myself first.

Any help would be greatfully received. Many thanks Eric

Replies:

Posted By: Powermyster
Date Posted: April 11, 2005 at 11:16 AM

sorry mate

what about a haynes manual..

Also it shouldn't be too hard to find what your looking for on the bike

Posted By: nava94
Date Posted: April 11, 2005 at 8:09 PM

it's a motorcycle just grab a digital meter and have at it. the wires shouln't be hard to find.

Posted By: Velocity Motors
Date Posted: April 11, 2005 at 8:12 PM

Battery, ground, ignition & parking lights are all running along the battery to the fuse panel. The horn you can grab at the horn itself.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: another-kelly
Date Posted: April 11, 2005 at 8:20 PM

all i can come up with:

YAMAHA / XJ 600 N OR S (UK) / 1992 / Remote Start[PRINT THIS PAGE]

12volts		starter solenoid bolt
Starter	blue/white	starter solenoid
Second Starter
Ignition	RED / white	ECU loom
Notes: Fuel pump wire is blue/black at fuel pump loom.
Second Ignition
Third Ignition
Accessory
Second Accessory
Keysense
Power Lock
Power Unlock
Lock Motor
Unlock Motor
Parking Lights+	green & brown
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger
Dome Supervision
Trunk/Hatch Pin
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer
Wait to start
Brake Wire
Parking Brake
Horn Trigger
Memory Seat 1
Memory Seat 2
Memory Seat 3

Posted By: EEZA
Date Posted: April 12, 2005 at 3:39 PM

Tell U what boys I expected a couple of posts but this has been great, I can of course probe and pin but its sooooo helpful to have an Idea, Its a pig to do as there's nowhere to hide the cables,,

I have so far just hooked up the power and LED / Siren. Had a stumble on the Flashers as it blows the fuse (I connected one side ok but when connecting to the other side it blows the fuse?) I guess I am gonna need to use the on board flasher for the hazard lights to get all flashing in unison (Currently the offside front and rear is active.

Many many thanks boys for the support.... Regards and all that Eric