1995 dodge caravan, prostart ct -3310

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100021
Printed Date: May 14, 2025 at 7:53 PM

Topic: 1995 dodge caravan, prostart ct -3310

Posted By: pszabadka
Subject: 1995 dodge caravan, prostart ct -3310
Date Posted: December 14, 2007 at 5:17 PM

I just installed a prostart ct -3310 on a 95 caravan. I hook up the wires like this

12 volts red ign harness

ignition dk blue ign harness

acc BLACK/ orange ign harness

starter yellow ign harness

tach RED / yellow coil pack

when i try to start with the remote it just cranks and does not start...... any ideas????? should i have to do something with the asd relay????

also i hook up the hatch release with a relay like this

30-sol side of trunk wire

87a- to switch side of trunk wire

86- trigger from remote starter

87 -12 volts

85-12 volts

trunk does not pop any ideas???

thanks

pat

Replies:

Posted By: moonliter
Date Posted: December 14, 2007 at 5:42 PM

Had u programmed the tach before u remote start ?

Posted By: pszabadka
Date Posted: December 14, 2007 at 6:57 PM

yes i did the auto tach

Posted By: moonliter
Date Posted: December 14, 2007 at 7:50 PM

So the tach learn is successful ?

Ok, u could try to start the caravan with the key, while it is running with the key, press the start on the remote. Remove the key and see whether the remote starter would take over.

Posted By: pszabadka
Date Posted: December 14, 2007 at 7:59 PM

it cranks for 8 seconds than shuts off

Posted By: moonliter
Date Posted: December 14, 2007 at 8:40 PM

moonliter wrote:

So the tach learn is successful ?
Ok, u could try to start the caravan with the key, while it is running with the key, press the start on the remote. Remove the key and see whether the remote starter would take over.

Did it die right away after u removed the key ?

Posted By: pszabadka
Date Posted: December 14, 2007 at 8:46 PM

i never tried to start it with the key then press the button the car is at my work. is it possible that there is a second ign wire. Pro start told me it was a lt blue but there was more than one, so i came here and look up the wireing diagram and it told me dk blue so i check ot with a multi meter and it was ok

Posted By: moonliter
Date Posted: December 14, 2007 at 9:11 PM

Is there a BLACK/ white wire at the ignition switch ? If it does then u need to connect it up as ignition 2.

Posted By: pszabadka
Date Posted: December 14, 2007 at 9:32 PM

i will check on monday

another quick question if my door locks are pos trigger and my starter is neg output how would i hook this up???

Posted By: pszabadka
Date Posted: December 14, 2007 at 9:34 PM

moonliter wrote:

Is there a BLACK/ white wire at the ignition switch ? If it does then u need to connect it up as ignition 2.

o just check on my alldata and there is a BLACK/ white wire that seems to go to the power windows and something else

Posted By: moonliter
Date Posted: December 14, 2007 at 10:22 PM

pszabadka wrote:

another quick question if my door locks are pos trigger and my starter is neg output how would i hook this up???

posted_image

u r right the BLACK/ white is the acc 2 not needed to be connected.

Posted By: pszabadka
Date Posted: December 15, 2007 at 8:56 AM

so what could be the problem