clifford 50.5 and dei 530t
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100072
Printed Date: May 13, 2024 at 6:15 PM
Topic: clifford 50.5 and dei 530t
Posted By: rt4x4
Subject: clifford 50.5 and dei 530t
Date Posted: December 15, 2007 at 10:39 PM
Hi , im going to install a 530t window module on a 2004 silverado with a clifford 50.5 and i was wondering if i need to diode isolate when hooking up the orange 530t to the orange h1/12 ground when armed wire,i was planning of using the channel 4 on the alarm what is the best setting for it to be, one more question what polarity does the module need to be setat +/-
Replies:
Posted By: rt4x4
Date Posted: December 16, 2007 at 7:11 AM
also can you hook up the orange wire from the 530t to a aux channel such as 4 or 5 and use that to roll the windows up?
Posted By: rt4x4
Date Posted: December 16, 2007 at 7:58 AM
is the module supposed to be set to - polarity for a 2004 silverado
Posted By: howie ll
Date Posted: December 16, 2007 at 1:36 PM
If you aren't using orange wire for anything else no diode needed. Other aux outputs can be used to roll down windows slightly (ie VENT). If you wanted to actuate the indow close facility independantly of arming the alarm, use another aux set to time it takes to close the windows + 2 secs, ie as a timed output. 2nd question, don't connect orange to any other aux outputs, third question, what do you mean by polarity? If this refer's to triggering the 530, use neg.
Posted By: howie ll
Date Posted: December 16, 2007 at 1:50 PM
Correction re the polarity question, I've just been on to directechs trade site and looked at the wiring etc. If you have a later version with the dip-switches, leave switch 5 OFF as in pos (+) setting
|