Print Page | Close Window

keyless remote programing

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10008
Printed Date: August 19, 2025 at 2:02 PM


Topic: keyless remote programing

Posted By: softsteelman
Subject: keyless remote programing
Date Posted: February 24, 2003 at 1:16 PM

Hi guys...I'm new to the 12 volt so please bare with me...looking for anyone who knows about programing keyless entry sysyems...oem sysyems..I'm working on 1) 98 chevy cavalier..system is intact but will not opperate  2)  99 jag  XJ8. new keyfobs obtained ...but now I need to program them one of the originals is still in hand....thanks for any input   Rick



Replies:

Posted By: BNLUIS
Date Posted: February 24, 2003 at 1:32 PM
Go to www.remotesunlimited.com and talk to Jeff or Email him. hope that helps  1-877-719-1900.

-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.



Posted By: Velocity Motors
Date Posted: February 24, 2003 at 4:28 PM
There are a couple of ways that I have to do the programming. Try these both:

Intrigue & 1997-98 Century & Regal
1. Sit in driver's seat.
2. Remove ignition key from ignition lock cylinder.
3. While holding door lock switch in unlock position, insert and remove ignition key twice. Do not rotate ignition lock cylinder.
4. Insert ignition key a third time leaving the key in the ignition lock cylinder. Ensure ignition remains in lock position for rest of procedure.
5. Release door lock switch. Three chimes should be heard to indicate transmitter programming is active.
6. Press and hold lock and unlock buttons of keyless entry transmitter for 12 seconds. Two chimes should be heard to indicate transmitter has been programmed successfully.
7. Repeat step 6 for additional transmitters.
Exit procedure by removing key from ignition lock cylinder.

Procedure # 2
1. Sit in driver's seat.
2. Remove ignition key from lock cylinder.
3. Ensure all doors are closed.
4. Remove the "MALL PGM" fuse from fuse panel.
5. Turn ignition lock cylinder to accessory position.
6. Turn ignition lock cylinder to off position and then back to accessory position within one second.
7. Open and close any door. A chime will be heard when remote control door lock receiver enters programming/diagnostic mode. If chime is not heard, repeat procedure as necessary.
8. Press and hold remote transmitter lock and unlock buttons for 14 seconds.
9. After 7 seconds, a chime should be heard confirming successful synchronization. After 14 seconds, a chime will be heard confirming successful programming.
10. Repeat step 8 for each additional transmitter.
11. Remove ignition key from ignition lock cylinder.
Install "MALL PGM" fuse to fuse panel.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA


Print Page | Close Window