98 crown vic abs light? remote start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100134
Printed Date: April 25, 2024 at 3:09 AM
Topic: 98 crown vic abs light? remote start
Posted By: jay3000
Subject: 98 crown vic abs light? remote start
Date Posted: December 17, 2007 at 3:53 PM
Hi,
Just finish installing a remote start on my 98 crown vic(PI). I used the all connection per diagram on this site. The abs light only comes on if I remote start the car but, not if I manaully crank up the car. Am I missing something? Thx for any help!
Scytek 5100rs is the remote start I'm using.
Replies:
Posted By: soultinter
Date Posted: December 17, 2007 at 4:04 PM
sounds like you missed an ignition or acessory wire
Posted By: jay3000
Date Posted: December 17, 2007 at 4:09 PM
Yes. I thought that too but, I have rechecked the wiring I was thinking maybe I need to relay something or something like that. Is there anyway that I can check the alarm brain and make sure its volting right?
Posted By: mauri197
Date Posted: December 17, 2007 at 4:53 PM
theres is an actual wire you are missing is your second accesory powerd up some cars are powerd up tru da accesory wires check again not all diagrams are correct
Posted By: extreme1
Date Posted: December 17, 2007 at 4:57 PM
should have 3 accesory wires powered.
grey / YELLOW, BLACK/ green and pink/black.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: jay3000
Date Posted: December 17, 2007 at 5:01 PM
Are you saying not to power up the BROWN / pink wire. Instead power the BLACK/ green?
Posted By: jay3000
Date Posted: December 26, 2007 at 10:46 AM
Hey guys,
i think i found something but i just need a little help with wiring up this relay. another site www.p71interceptor.com/ says i need to run an external relay due to high current draw will anybody help me with this pin out on the relay. i have a spdt relay. https://www.p71interceptor.com/remotestart/9802table.html
Posted By: tedmond
Date Posted: December 26, 2007 at 11:08 AM
the scytek should should be able ot handle the high current draw. if youare worried it might not be sufficiant wire up a relay like so. 85 - Ground
86 - Ignition input (+) from scytek remote start
87 - high current 12v
30 - to second Ignition wire. the reason you are gettin airbag light, itsbecause you did not wire up your THIRD ignition
Posted By: jay3000
Date Posted: December 26, 2007 at 11:12 AM
thx in advance
|