02 subaru outback, compustar

I am installing a compustar in one today, and i cant find a wiring diagram, can anybody help?  Other than that, any pointers?

12 VOLTS	BLACK/ white or White	Ignition switch harness	+
The wires change color at a BLUE connector on the steering column. Check both sides of the plug for these colors.
IGNITION	Black or Green	Ignition switch harness	+
The wires change color at a BLUE connector on the steering column. Check both sides of the plug for these colors.
ACCESSORY	BLACK/ blue or Yellow	Ignition switch harness	+
The wires change color at a BLUE connector on the steering column. Check both sides of the plug for these colors.
STARTER	BLACK / YELLOW or WHITE/ black	Ignition switch harness	+
The wires change color at a BLUE connector on the steering column. Check both sides of the plug for these colors.
KEY SENSE	WHITE/ green	At steering column	+
TACH SIGNAL	RED / green or WHITE/ black	At coil on top of engine	AC
On the 2.5L, tach is RED / GREEN or WHITE/ BLACK at a 4-pin plug at the coil. (see photo)
FUEL INJECTOR	Opposite from Yellow	At any injector on engine	AC
LOCK	White	In driver's kickpanel	-
See photo (Subaru Legacy & Outback 2001 & up - Doorlocks).
UNLOCK	Dk.GREEN/ red	In driver's kickpanel	-
See photo (Subaru Legacy & Outback 2001 & up - Doorlocks).
DOORPIN	Pink/black	See notes	-
Located at a WHITE 15-pin plug on the left side of the steering column. If the vehicle has no keyless entry, this connector is taped up to the fusebox. See available diagrams for details.
TRUNK PIN	Yellow/blue	See notes	-
Located at a WHITE 15-pin plug on the left side of the steering column. If the vehicle has no keyless entry, this connector is taped up to the fusebox. See available diagrams for details.
FACTORY ARM	See notes
There are no external arm and disarm wires on the security system. For remote start installations, you will need to open ignition sense at the alarm and keyless entry modules. See the available diagram for details.
FACTORY DISARM	See notes
There are no external arm and disarm wires on the security system. For remote start installations, you will need to open ignition sense at the alarm and keyless entry modules. See the available diagram for details.
BRAKESWITCH	WHITE/ black	At switch above brake pedal	+
PARKLIGHTS	Orange	At steering column	-
You must test for this wire with the ignition turned on.
HAND BRAKE	Pink	See notes	-
Located at a WHITE 15-pin plug on the left side of the steering column. If the vehicle has no keyless entry, this connector is taped up to the fusebox. See available diagrams for details.
HORN	RED / green	At steering column	-

If you DO NOT use the factory transmitters.... you will NOT need to worry about the factory alarm at all.......

-------------

thanx ktm, your the man.