ez 2500 on 07 corolla not working
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100362
Printed Date: May 17, 2024 at 8:08 PM
Topic: ez 2500 on 07 corolla not working
Posted By: revobreaker
Subject: ez 2500 on 07 corolla not working
Date Posted: December 23, 2007 at 7:26 PM
Equipment:
07 corolla S
PKT2 bypass kit
Commando EZ 2500
trunk popper from commando
Using the wiring diagrams I found on this website(thanks they have been a real help) I have installed the EZ 2500 module. The doors lock and unlock fine, the horn and parking-lights beep and flash, the trunk pops good.
The car will not remote start. It will not do anything, I do not hear the EZ module relays click, I do not get any voltage output on the starter or ignition wires. I have checked that all the necessary wires are powered and grounded properly. Tomorrow I will step through all of the programing again, and if that doesn't work I guess I'll call commando (although I don't like their tech support).
This is the first RS I have installed, but I am a electronics technician at my day job, so I know what I'm doing. If there is any help someone can give me I would appreciate it.
Sorry for being long-winded, just trying to get all my info out there.
Replies:
Posted By: jrilla
Date Posted: December 23, 2007 at 8:23 PM
It has been a while since I have installed one of those, and I don't have the manual but I thought you needed to program the unit to be able to remote start. Look at the programming features and there should be one level that enables remote starting.
Posted By: Velocity Motors
Date Posted: December 23, 2007 at 8:24 PM
Did the unit program the tach properly ? Make sure that the fuses are good on both side of the RED wires and also make sure that there's no cold solder points.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: revobreaker
Date Posted: December 26, 2007 at 8:46 PM
Thanks for the quick and informative replys. It was the tach programing, I had to go through it a few times. Their instructions are a little vague but I got it all working and its great!
Thanks for all the help, I'm sure I will be back on these forums anytime I need information. Kudos to the12volt.com!!!!
|