remote start on 2004 tahoe
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100513
Printed Date: May 03, 2024 at 4:40 AM
Topic: remote start on 2004 tahoe
Posted By: helmsb
Subject: remote start on 2004 tahoe
Date Posted: December 28, 2007 at 1:15 PM
Just installed a Valet model 562t and a XK01 doorlock & alarm interface. It works fine but when I use the remote start the service engine light comes on and the trans does not shift right. If you use the key it runs fine. Any ideas
Replies:
Posted By: usabuilt
Date Posted: December 28, 2007 at 2:52 PM
make sure you have 2nd ign hooked up white wire, and accessory orange wire, also make sure the 2nd ign does not drop out when the engine cranks.
Posted By: helmsb
Date Posted: December 28, 2007 at 4:35 PM
Just cheked wiring looks right. I am going to get meter to chek for drop out. I think there is also a brown acc wire from the switch , does it have to be tied in to the remot start.
Posted By: helmsb
Date Posted: December 28, 2007 at 5:25 PM
this is what I got from switch red=12 volt red-white=12 volt pink is hot with ing then drops to 9.8 volts at start orange is hot in run only white is hot in acc and run but drops to 9.8 at start brown is hot in acc and run only. The relay satellite that these wire go to has another hot wire that it says to use if it is needed , how do you know if it is needed?
Posted By: saskpuller
Date Posted: December 29, 2007 at 6:56 AM
The aux relay must be set to igntion and wired to the white wire that is up there beside the brown and orange wires. This is your second igntion and is required to prevent tranny damage among other things.
Posted By: helmsb
Date Posted: December 29, 2007 at 5:19 PM
today added 12 volts to the wire that is to be used if you need extra power to and everything works. I have set everything up but to unlock doors you have to push the unlock button 3 times. The first time you push the relay clicks but does nothing. 2nd time it relocks the doors and the 3rd it unlocks.
|