Print Page | Close Window

2003 trailblazer door unlock problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100543
Printed Date: May 30, 2024 at 3:29 AM


Topic: 2003 trailblazer door unlock problem

Posted By: iammbs
Subject: 2003 trailblazer door unlock problem
Date Posted: December 29, 2007 at 2:53 PM

I am having problems with the doors unlocking on my 2003 Trailblazer. I am using a DEI VALET system with an XK01 bypass kit. The Autostart, and door locking work fine. The UNLOCK problem seems to be associated with the factory security. After pressing Unlock/Disarm on the Valet Autostart/Keyless entry remote, I can't even manually ground the input to the XK01 and unlock the doors.

There seems to be an 8-10 second window of time after disarming the system that the vehicle will not accept the signal. The vehicle even tries to lock the doors again after 8-10 seconds have elapsed since disarming the system.

Here are some details:

With Lock/Unlock wires connected from Valet to XK01

When Locking/Arming system

All Doors Lock

Interior lights turn on for 16 seconds or so

Security Light on Dash turns on for 30 seconds or so

Parking Lights flash once

Windows roll up sometimes. Usually the front 2 windows roll up together, then the driver side rear, then passenger side rear.

Status LED starts flashing

When Unlocking/Disarming

Doors DON'T unlock. The vehicle tries to lock doors 10 seconds after Disarming even though there still locked. The dashboard security light comes on simultaneously when the vehicle tries to lock the doors.

Interior lights come on immediately when disarming

Parking lights flash twice

Status LED stops flashing

With XK01 Unlock wire (Green) disconnected

The doors will still not unlock if I manually ground the Green wire within 8-10 seconds after disarming the system. The vehicle tries to lock the doors after 8-10 seconds even though there still locked.

The doors will unlock if I ground the green wire AFTER the vehicle tries to lock the doors, which is 8-10 seconds after disarming the system

The doors will unlock if I ground the green wire while the system is armed also. Actually, 1 tap to ground unlocks driver door and 2 taps unlocks all doors.

I hope this is enough detail. I really appreciate the help.

Mike




Replies:

Posted By: ziadmoh
Date Posted: December 29, 2007 at 10:21 PM
First, make sure you have an AMDL firmware downloaded into your XK01.
Then, confirm that XK01 (GRN) is connected to (-) lock wire from RS.
    XK01 (BLU) is connected to (-) Unlock wire from RS.
If non of them worked, contact Bypasskit tech support.
Also, did u go through programing the kit to make sure that it is on MODE1?
Good luck




Posted By: iammbs
Date Posted: December 29, 2007 at 11:24 PM

Yes, I checked to make sure it's in MODE1.  How do I know if the XK01 has the AMDL firmware loaded?

Thanks for the reply.






Print Page | Close Window