Print Page | Close Window

crime guard 533i2

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100672
Printed Date: May 29, 2024 at 12:55 AM


Topic: crime guard 533i2

Posted By: bill49129
Subject: crime guard 533i2
Date Posted: January 02, 2008 at 6:12 AM

i had to install a new battery in my 90 Cherokee and now the remotes dont work for the alarm and i cannot start the jeep.....how do i re-program them???



Replies:

Posted By: 519civiconair
Date Posted: January 02, 2008 at 9:45 AM
METHOD #6
Before you begin, your system must be in a disarmed state and you must know where your valet switch is located. If you are unfamiliar with your valet switch, click here. If you know where your valet switch is, perform the following steps:

1) Turn the vehicle's ignition "on" then "off".

2) Within 7 seconds of step 1, press the valet switch 5 times. The alarm should respond with a long siren chirp.

3) Press the valet switch one time to enter transmitter programming mode.

4) Press the large/ lock button on your remote. The alarm should respond with a short siren chirp.

5) Repeat step 4 for each additional remote that is to operate the system (up to 4 remotes).

Note: the system will automatically exit programming mode if it detects a 15 second period of no activity.

-------------
F.B.S.S air ride is the only way to roll


Print Page | Close Window