Print Page | Close Window

Hi check level Low check Autopage750

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10070
Printed Date: January 16, 2026 at 2:02 PM


Topic: Hi check level Low check Autopage750

Posted By: floaterr
Subject: Hi check level Low check Autopage750
Date Posted: February 25, 2003 at 3:28 PM


What is the low check and high check on the programming of the remote start on the Autopage 750LCD?

I have an autopage that cranked to fast to start the vehicle and then with voltage sensing didnt notice that the truck failed to start and sent the started signal to the remote. Would this setting correct that issue?



Replies:

Posted By: securinu
Date Posted: February 25, 2003 at 3:39 PM
the hi check and lo check is in regards to the tach wire . some cars have computers with higer voltages . this only come into play when tach wire is connected and wont start all the time. you can switch to lo and see if it works.


Print Page | Close Window