immobiliser bypass, 01 honda civic

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100738
Printed Date: May 23, 2024 at 5:05 PM

Topic: immobiliser bypass, 01 honda civic

Posted By: Rbalan
Subject: immobiliser bypass, 01 honda civic
Date Posted: January 04, 2008 at 9:52 AM

Hello and Happy New Year to everybody.

I installed a Prostart remote starter on an 01 Honda Civic. I'm not able to program the immobiliser byPass (PKH3). I've two wires left un connected of PKH3 green and brown. In the diagram it says green N.C. and for Brown it says GWR. I would appreciate if any body could help me out with the brown wire. I don't know what GWR stands for.

Thanks in advance for all the help

Replies:

Posted By: Twelvoltz
Date Posted: January 04, 2008 at 12:16 PM

What model number is the RS you are installing?

The brown wire needs to be connected to your ground while running (GWR) output from the RS system. Most systems label it as a ground when running output but on DEI systems it is labeled as status output and normally blue or blue/white.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: moonliter
Date Posted: January 04, 2008 at 3:00 PM

GWR is the only white wire (10) in the 12 pin wire harness.

Make sure you program the module with the black key only.

Posted By: Rbalan
Date Posted: January 21, 2008 at 10:20 AM

Thanks all of you.It was agreat help

Print Page | Close Window