95 caprice remote start w/no status output
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100796
Printed Date: May 14, 2024 at 11:36 AM
Topic: 95 caprice remote start w/no status output
Posted By: Reeceddogg
Subject: 95 caprice remote start w/no status output
Date Posted: January 05, 2008 at 6:31 PM
I'm working on a car that already had an alarm and R/S installed. The R/S was never installed i'm guessing, because there's no status output. I have no idea of the alarm but it does have a diagram on the back. The car is a 95 caprice. i could only come up with diode isolating the ignition wire to activate the relay for the bypass. Any thoughts?
Replies:
Posted By: Reeceddogg
Date Posted: January 05, 2008 at 10:35 PM
Any one think of something?
Posted By: KarTuneMan
Date Posted: January 06, 2008 at 7:53 PM
How could a remote start NOT have a ground while running (status)? What type of unit is it? -------------
Posted By: Reeceddogg
Date Posted: January 06, 2008 at 8:17 PM
Have no idea of the unit just has a diagram on the back of brain. No name on key fobs or brain.
Posted By: KarTuneMan
Date Posted: January 06, 2008 at 11:58 PM
Nothing negative out when running?
-------------
Posted By: Reeceddogg
Date Posted: January 07, 2008 at 12:41 AM
Nope. has power, ground, built in door lock relays, ignition input, starter kill output, brake, negative door trigger, siren out, 2 parking light outputs, + trunk pop, led, shock sensor, built in antenna, tach, dome supervision, seperate remote start relay pack, remote start output that plugs into remote start relay pack. doesn't even have a valet switch. made in china 2000.
Posted By: brhaugen
Date Posted: January 07, 2008 at 8:05 AM
Could you find the (-) for ignition in the cable between the module and the remote relay pack??
Posted By: mobile1
Date Posted: January 07, 2008 at 10:43 AM
There has to be a trigger wire in the connection between the brain and relay pack to activate the ignition relays. It will probably be (-). I would test these wires.
Posted By: Twelvoltz
Date Posted: January 07, 2008 at 11:29 AM
X3 on using the ribbon cable negative ignition turn on.
-------------
Installer, IT support, and FFL. I need less hobbies.
Posted By: Reeceddogg
Date Posted: January 07, 2008 at 1:43 PM
Good idea. something has to be negative in there. And better yet its not a ribbon cable but three 18ga wires. i'll check now.
Posted By: Reeceddogg
Date Posted: January 07, 2008 at 1:45 PM
Good idea. something has to be negative in there. And better yet its not a ribbon cable but three 18ga wires. i'll check now.
|