Dual Zone Sensors
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10093
Printed Date: August 14, 2025 at 2:52 AM
Topic: Dual Zone Sensors
Posted By: Ry99
Subject: Dual Zone Sensors
Date Posted: February 25, 2003 at 11:17 PM
Hello, I have a dual zone radar sensor hooked up to my Viper 790xv. It seems like the pre-warn and alarm triggers are mixed, but I didn't do the install myself and am not sure what the installer did. I know the red wire is power, black is ground, and then what typically are the green and blue wires? Is one an output for warn and another for full trigger? Please let me know of any information that would be helpful. Thanks!
Replies:
Posted By: JWorm
Date Posted: February 25, 2003 at 11:31 PM
Either it wasn't adjusted properly or it was hooked up to the blue "instant trigger" wire of the main harness. It should have been hooked up to the green wire on the shock sensor harness that is not connected to anything.
Posted By: Ry99
Date Posted: February 26, 2003 at 11:26 AM
Ok, so you are saying that the green wire coming out of my shock sensor (which literally comes out of the harness and loops right back into where it comes out of) should be the wire that it is hooked up to? And which wire of the sensor should be hooked up to this wire? From the sensor, the red is power, black is ground, and then there is a blue and green one. Which goes to the shock sensors' green wire and where does the other one go? Thanks a lot for your help!
|