05 titan window wire colors
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101033
Printed Date: June 01, 2024 at 12:26 AM
Topic: 05 titan window wire colors
Posted By: big d z
Subject: 05 titan window wire colors
Date Posted: January 10, 2008 at 9:32 PM
Anyone have the wire colors for the window controls for all four windows and possibly the rear window?
Thanks,
Brandon
Replies:
Posted By: another-kelly
Date Posted: January 10, 2008 at 9:58 PM
audiovox lists:
LF Window Up GREEN/ RED (REV) WINDOW SWITCH IN DRIVERS DOOR
LF Window Dn GREEN / WHITE (REV) WINDOW SWITCH IN DRIVERS DOOR
RF Window Up BLUE (REV) DRIVER DOOR HARNESS IN KICK PANEL
RF Window Dn GREEN (REV) DRIVER DOOR HARNESS IN KICK PANEL
LR Window Up RED / YELLOW (REV) DRIVER DOOR HARNESS IN KICK PANEL
LR Window Dn RED / BLACK (REV) DRIVER DOOR HARNESS IN KICK PANEL
RR Window Up BLUE (REV) DRIVER DOOR HARNESS IN KICK PANEL
RR Window Dn RED (REV) DRIVER DOOR HARNESS IN KICK PANEL
Posted By: big d z
Date Posted: January 11, 2008 at 6:20 PM
another-kelly wrote:
audiovox lists:
LF Window Up GREEN/ RED (REV) WINDOW SWITCH IN DRIVERS DOOR
LF Window Dn GREEN / WHITE (REV) WINDOW SWITCH IN DRIVERS DOOR
RF Window Up BLUE (REV) DRIVER DOOR HARNESS IN KICK PANEL
RF Window Dn GREEN (REV) DRIVER DOOR HARNESS IN KICK PANEL
LR Window Up RED / YELLOW (REV) DRIVER DOOR HARNESS IN KICK PANEL
LR Window Dn RED / BLACK (REV) DRIVER DOOR HARNESS IN KICK PANEL
RR Window Up BLUE (REV) DRIVER DOOR HARNESS IN KICK PANEL
RR Window Dn RED (REV) DRIVER DOOR HARNESS IN KICK PANEL
Well, this is sorta correct.
I found these wires:
LF up/down to be GREEN/ red and GREEN / WHITE at switch drivers door.
LR up/down to be RED / yellow and RED / black at door harness
RR up/down to be red and blue at door harness
Now, the problem is with the RF window. This window's switch also has a "one-touch" control for the front passenger. This may be the issue. Out of all the wires in the driver door harness, only when I test this one small green wire for a ground, does the window stop operating.
So, do I need to run wires into the front passenger door in order to make this window work?
Posted By: extreme1
Date Posted: January 11, 2008 at 9:07 PM
why don't you just use the driver key cylinder wires to do roll up and down.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: big d z
Date Posted: January 12, 2008 at 11:40 AM
extreme1 wrote:
why don't you just use the driver key cylinder wires to do roll up and down.
Huh? Elaborate please...
Posted By: offroadzj
Date Posted: January 12, 2008 at 10:07 PM
i was jsut about to post the same thing. If you hold a ground on the lock wire, all of the windows should roll up... and if you hold a ground on the unlock wire, the windows should roll down. I do not believe that you have to necessarily go to the key cylinder, but that may be required.
-------------
Kenny
Owner / Technician
KKD Garage LLC
Albany, NY 12205
Posted By: big d z
Date Posted: January 13, 2008 at 1:39 PM
offroadzj wrote:
i was jsut about to post the same thing. If you hold a ground on the lock wire, all of the windows should roll up... and if you hold a ground on the unlock wire, the windows should roll down. I do not believe that you have to necessarily go to the key cylinder, but that may be required.
Is this similar to using the factory key fob? If so, I can only roll down the front two windows. I'm not able to roll them up and the back two windows don't work either.
Also, does doing this allow the windows to vent?
Posted By: big d z
Date Posted: January 14, 2008 at 10:40 AM
Ok, I have a big problem with the operation of the driver window now.
I have the 530T install. Using channel 4, the window rolls down. When I arm the system, the window rolls up. So, it seems to be working for that.
But what is really screwed up is the operation from within the truck. I can no longer roll the window down partially. The drivers control has auto windows. The switch had two ways to move the window. Just slightly pressing the switch caused the window to move. Release this pressure and the window stopped. To auto-roll it, I had to push the switch all the way down pass a "click". Then the window moved the full extent.
Now, if I just slightly press the switch to move the window it moves the whole way. I cannot just move the window partially and make it stop.
Posted By: big d z
Date Posted: January 15, 2008 at 2:09 PM
Now another odd occurrence. When I roll the window up using the drivers switch, the drivers window will sometimes reach the top and then just roll back down. wth??
|