mars 11 status output?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101148
Printed Date: May 04, 2024 at 5:16 PM

Topic: mars 11 status output?

Posted By: stroker@techie
Subject: mars 11 status output?
Date Posted: January 14, 2008 at 12:09 PM

putting a mars-11 remote start in a 05 pathfinder,07 sante fe,and 06 tucson using 556uw. The 556uw calls for a (-) status input what wire would this be on the mars-11?

Replies:

Posted By: chriswallace187
Date Posted: January 14, 2008 at 4:28 PM

Generally on MARS11s I've used the blue 22 gauge ignition wire from the 3-pin plug. The orange anti-grind output may also work; however I can't say with 100% certainty that it's active before the car actually cranks.

-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two

Posted By: customak47
Date Posted: January 16, 2008 at 3:13 PM

it is the thin gauge ignition 3 negative output you need to use off the mars unit...

-------------
My rifle is my friend...

Posted By: audiomaninc
Date Posted: January 16, 2008 at 3:23 PM

I've always used the thin orange wire in the main harness. This is used for the starter anti grind output and also works well for connecting a bypass. The third ignition wire will also work, but IMO it just adds to the clutter.

-Jason

Print Page | Close Window