one wire push buton starter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101213
Printed Date: May 20, 2024 at 4:30 AM

Topic: one wire push buton starter

Posted By: heavyhopper
Subject: one wire push buton starter
Date Posted: January 15, 2008 at 11:02 PM

building a 37 ford for a customer, with 350 chev, yadda yadda, and it has a stock 1 wire push button starter that he wants to use, any way to use this , i will be using a reg key ignition but he wants to retain the stock push button start. i want to go to a 2 wire button but he wants to use the original any ideas thanks

Replies:

Posted By: KPierson
Date Posted: January 16, 2008 at 6:27 AM

If it is a one wire system you should be able to wire it to a relay and make it a 'two wire' switch. I'm guessing the other side of the contact is the metal body that the switch is in?

If the frame is (-) grounded then the output will go to the (-) side of the relay coil. If the frame is (+) grounded then the output will go to the (+) side of the coil.

-------------
Kevin Pierson

Print Page | Close Window