2008 buick lucerne
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101249
Printed Date: May 14, 2024 at 4:30 PM
Topic: 2008 buick lucerne
Posted By: kaczarcollision
Subject: 2008 buick lucerne
Date Posted: January 16, 2008 at 9:24 PM
has anybody had any issues with starter delays and which way to wire the starter and ignition wires in the 08 buick lucerne. i am dumbfounded. i am using a xk06 antitheft and pkugm2x for locks. the starter initializes and does not crank. bypasses programmed successfully and the locks work just no crank. any help would be greatly appreciated.
-------------
disturbing the peace since 1984
Replies:
Posted By: Velocity Motors
Date Posted: January 17, 2008 at 12:10 PM
What wire did you use for your voltage reference and your resistor wire ? Also, the PKUGM2X requires that you wrap the transponder wire around at least 3-5 times, but I've found that it need to be more like 6-8 times and I use CAT5 wire instead.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: extreme1
Date Posted: January 17, 2008 at 1:08 PM
xk06 takes care of ign/immo for the vehicle, okugm2x does the same only with an active transponder instead of data.
I think you've overdone the bypass thing a little.
maybe switch out to an idatalink ads-dlsl-gm3 and make your life easier.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: kaczarcollision
Date Posted: January 18, 2008 at 10:13 AM
i used the wiring data from directtechs if that helps. im sure i have the bypass' wired up fine and programmed correctly. i'm just a little unsure of my big gauge starter, ign, etc. connections. ?/
-------------
disturbing the peace since 1984
Posted By: backinblack
Date Posted: January 18, 2008 at 10:34 AM
Make sure you activate the key sense wire when you remote start. I have found that if you do not, it will not crank.
|