fortin int sl
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101290
Printed Date: April 23, 2024 at 7:12 PM
Topic: fortin int sl
Posted By: Memphisman
Subject: fortin int sl
Date Posted: January 17, 2008 at 6:15 PM
Is anybody having problems with the Fortin INT-SL bypass Module? I recently started using them and everyone of them has come back with the same problem. After being used for 3 or 4 days, when you use the RS you cant shut the vehicle down with the brake or key. You have to let it run its preset time.
Replies:
Posted By: johnmax
Date Posted: January 17, 2008 at 7:22 PM
I've used a couple. Havent seen that, but did have a CTS that it would not bypass if left sitting for a while.
Posted By: robertsc
Date Posted: January 17, 2008 at 7:27 PM
sounds like your starter is not seeing your brake output are you using output from your brake switch or your bypass
Posted By: Velocity Motors
Date Posted: January 17, 2008 at 7:29 PM
What version numbers do you have ? Are the version numbers the most recent for the vehicles that they're installed into ?
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: Memphisman
Date Posted: January 17, 2008 at 8:10 PM
I'm using the ouput from the bypass and the version I have is 2.5.
Posted By: johnmax
Date Posted: January 18, 2008 at 2:43 PM
Yeah sounds like the brake output of the module is messed up. Wire it up to the brake switch.
Posted By: tedmond
Date Posted: January 18, 2008 at 3:32 PM
just wire it the brake switch. its a one min job and its more reliable. i never rely on outputs from datakits such as tach, hoodpin and brake output. on Fortin SL2, the tach output is wack, it works at times and sometimes it just doesnt work ahah hope they fixed this.
Posted By: dswift
Date Posted: January 18, 2008 at 3:49 PM
never heard of this issue. But i'll note it. How many INTSL you've installed and the brake switch doesnt work.
-------------
"dont ground out!"
Posted By: Memphisman
Date Posted: January 18, 2008 at 8:26 PM
I've used 7 so far. All came back.
Posted By: tedmond
Date Posted: January 18, 2008 at 9:40 PM
use 4. had issues with tach mostly and the hood status. it kinda lags like you can open the hood and almost 20 seconds after it will trigger.
Posted By: johnmax
Date Posted: January 23, 2008 at 5:48 PM
Well last 2 i used the tach was unreliable. Worked for a little while, then went to RS it and pull it out of the shop no good. Hooked up tach the old fashioned way and bye bye. Using Audiovox RS. I remember seeing Idatalink say that their mods only put out a 5v tach signal and some RS units don't like seeing that low of a signal. Maybe the same with Fortin.
|