Print Page | Close Window

need diagram 2007n sebring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101295
Printed Date: May 12, 2025 at 11:12 AM


Topic: need diagram 2007n sebring

Posted By: stevet
Subject: need diagram 2007n sebring
Date Posted: January 17, 2008 at 7:47 PM

Anyone have a diagram? Looking for the starter circuit, it's not on the ignition harness is it on the BCM just left of the fuse block? and what plug and pin number is it?

Thanks

Steve



Replies:

Posted By: KarTuneMan
Date Posted: January 18, 2008 at 11:20 AM
Yes... it is. It's right under the key.

-------------




Posted By: stevet
Date Posted: January 19, 2008 at 11:15 PM
Under the key???" there are only 4 wires on the ignition harness coming off the key cylinder. What color wire is it??"?"??" What about a diagram folks!




Posted By: Chris Luongo
Date Posted: January 20, 2008 at 10:51 AM
What product are you installing? There are many ways to save a lot of time on these cars; they're easy.

As there are only four wires at the keyswitch, it shouldn't take more than 10 seconds or so to test them.

One constant, one ignition, one ground, and one that tests as ground when cranking....it's supposed to get ground through a 180-ohm resistor for start.




Posted By: stevet
Date Posted: January 20, 2008 at 9:57 PM
Thank you, that's what I needed to know.





Print Page | Close Window