07 dodge ram, autostart 2451, xk05

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101520
Printed Date: April 28, 2024 at 8:09 AM

Topic: 07 dodge ram, autostart 2451, xk05

Posted By: ervie
Subject: 07 dodge ram, autostart 2451, xk05
Date Posted: January 24, 2008 at 2:40 PM

im installing a autostart 2451 with an xk05 my problem is that the bypass wont program.

I just found out the owner of the truck has 3 keys, all 3 have the chip and the lock and unlock buttons.

Any way could it be that the truck wont allow the bypass to program because there are 3 keys already.

Replies:

Posted By: Velocity Motors
Date Posted: January 24, 2008 at 3:48 PM

Dod ge vehicles allow 4 keys to program to anyone BCM. Chances are you are not holding the module close enough when your cycling the ignition. Remove the board from the module case so show off the chip and this will allow you to get the chip very close to the ignition column to program.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: ervie
Date Posted: January 24, 2008 at 4:13 PM

actually i did that with the same results

Posted By: ralphtonka
Date Posted: January 24, 2008 at 4:16 PM

manual says up to 8 keys, chrysler mods can only me programmed once. try a new mod

Posted By: ervie
Date Posted: January 24, 2008 at 4:20 PM

i tried e mods lol so i finaly used an xk 530 and put in the key and fired right up.

by the way the post says xk05 but its was an xk 532 sry bout that

Print Page | Close Window