Print Page | Close Window

connecting 556cw to 562t

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101674
Printed Date: July 12, 2025 at 3:32 PM


Topic: connecting 556cw to 562t

Posted By: atrus
Subject: connecting 556cw to 562t
Date Posted: January 28, 2008 at 8:31 PM

I have a DEI 562T in a 2007 Jeep Liberty. I am using the DEI 556CW sentry bypass module.

Currently, I have the red wire on the 556C to constant (+) power. I have the blue wire (-) going to the relay satellite ribbon cable, the violet wire (-200mA starter output).

I figured this would be correct as it'd trigger the unit when starting, then shut off. The vehicle doesn't like this and shuts itself down. If I manually ground the 556C, it works perfectly.

So, which wire should I use for the ground? Should I use the blue (-) status output or the pink (-) ignition output, or some other one?

Thanks!!!




Replies:

Posted By: StealthEs
Date Posted: January 28, 2008 at 8:43 PM
use the blue status wire.

-------------
Cris



Posted By: atrus
Date Posted: January 28, 2008 at 8:53 PM
Excellent, thank you. I'll go connect it right now!


Print Page | Close Window