wiped out a 300m key?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101685
Printed Date: May 03, 2024 at 7:51 AM
Topic: wiped out a 300m key?
Posted By: tintman97
Subject: wiped out a 300m key?
Date Posted: January 29, 2008 at 11:19 AM
I started to program a IBUCH and my wire jumper wire alligator clip came loose. Now the factory keys WONT start the car the security light dont even come on? What happened and what can I do this Is a first for me ive done tons of IBUCH and never ran into this.
Snapper
Replies:
Posted By: dmielken
Date Posted: January 29, 2008 at 8:19 PM
Perhaps a blown fuse? Possibly an ignition somewhere under the dash or hood. Check that possibility first. Check them all just to be sure though.
Posted By: tintman976
Date Posted: January 29, 2008 at 10:16 PM
no starts fine just wont run. Security light never even turns on. What did i do to do this what was the fatal combo? Im not the only person this has happened to, none of the other posts were updated. Cars at the dealer now hope in the morn they figure it out.
Snapper
Posted By: StealthEs
Date Posted: January 29, 2008 at 10:23 PM
Did you try it with their 2nd key ?
-------------
Cris
Posted By: corrysmtx
Date Posted: January 30, 2008 at 8:03 PM
Have you tried it again since then it might have gone into a security mode where the car will not allow tthe car to be started an could stay like that for a while. it is easier to program those boxes if you take one of the keys apart and use the empty key with the bypass box.
-------------
1 12" mtx 9500 4ohm dvc 1 8100d and 1 1501d almost loud enough to cover the sounds of my car dying.
Posted By: tintman97
Date Posted: January 30, 2008 at 8:43 PM
Oh yah tryed again nope the skim is dead had to replace. 275.00 later, I think im just done messin with these chrysler products never have like working on them.
Snapper
Posted By: StealthEs
Date Posted: January 30, 2008 at 10:19 PM
Was it just the key or they had to replace a whole new skim module?
-------------
Cris
Posted By: tedmond
Date Posted: January 31, 2008 at 7:10 AM
i think he had to replace the whole skim module, ouch
Posted By: tintman976
Date Posted: January 31, 2008 at 8:12 PM
the skim and both keys. Thats what the dealer said ill pick it up and the blown parts and useless keys. Ill bet a dollar they already "disposed" of them. Im questioning if I want to finish off the RS or not. Any opinions 275.00 for skim module and 2 keys 54.00 towing.
Snapper
Posted By: tonyberg
Date Posted: February 01, 2008 at 9:13 AM
Thats not overly unreasonable, I checked here we charge 140.00 for the SKIM module. Im guessing at least 30 bucks per key. so thats 200 and 75 bucks labor at a dealer is CHEAP. our door rate is 90
Posted By: brhaugen
Date Posted: February 01, 2008 at 1:19 PM
That's nothing,
I somehow blew up a customers' PCM on a 05 Accord.
$1200 later.....
NOW I have insurance.
|