Need help Again.
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10170
Printed Date: July 20, 2025 at 11:38 AM
Topic: Need help Again.
Posted By: Anthony1
Subject: Need help Again.
Date Posted: February 27, 2003 at 5:50 PM
Everything is hooked up for my led scanner I connected the red wire to constant 12 volt, the black to a ground, and the yellow to the orange wire on my rattler 300 (- 500ma when armed only), but the led will not shut off. When I arm the alarm it will just light up, and stay lite-(no flash patter), when not armed still stays lite but will go through the patterns. Anyone know what I did wrong?????
Replies:
Posted By: jayts95
Date Posted: February 27, 2003 at 5:58 PM
you will need to add a diode on the orange wire. cut the orange wire place a 1 amp diode in line with the stripe side of the diode facing the alarm side. Now connect your yellow wire from your led to the orange wire (ground when armed) between the diode and the alarm. This should take care of your problem.
Posted By: Anthony1
Date Posted: February 28, 2003 at 5:35 AM
okay thanx!!! what will this do? The stripe will be closer to the alarm? I am not very good with this stuff. Sorry.
|