Print Page | Close Window

06 pontiac g6 ads dlsl gm?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101723
Printed Date: May 19, 2024 at 1:29 AM


Topic: 06 pontiac g6 ads dlsl gm?

Posted By: bruc007
Subject: 06 pontiac g6 ads dlsl gm?
Date Posted: January 30, 2008 at 6:43 PM

Hey guys ,I've got a 06 g6 gt to do this weekend and waswondering if anyone has used this bypass and are there areany tips I should know about its operation..It's the first dual security vehicle Ive done.This kit seems to be able to do it all.Use this site and navigate to the year and make to see the kit.
Thanks Bruce

https://www.idatalink.com/prostart/https://www.idatalink.com/prostart/



Replies:

Posted By: Velocity Motors
Date Posted: January 30, 2008 at 6:49 PM
The module works great on all the PK3+ systems. Integrates flawlessly for door locks, trunk release, door triggers and bypass.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: bruc007
Date Posted: January 30, 2008 at 6:55 PM
Thanks Jeff, A couple of questions, in the manual the tach output wire is red and the instructions are hazy.Is this a good tach source?Or is it even usable.Does the RAP wire have to be hooked up to this vehicle?

Thanks again,Bruce




Posted By: StealthEs
Date Posted: January 30, 2008 at 6:57 PM
looks very straight forward. shouldn't be anything to hard. Almost like the Nissans where you need to interrupt the security light. I've used a ton of Idatalink module for different car haven't had any problems aside from note fully read the directions.

-------------
Cris




Posted By: StealthEs
Date Posted: January 30, 2008 at 6:59 PM
If you alarm is capable of doing the 2way through the Idatalink you dont need to hook it up, if not just hook it up to the tach wire on the remote start unit.

-------------
Cris




Posted By: StealthEs
Date Posted: January 30, 2008 at 7:01 PM
AS far as for the RAP system that would again fall into if your unit is 2way capable if not just follow these notes. A rap shutdown (-) output, with thePURPLE / black wire connected to ground. The greenwire must be connected to the driver door switchto turn off radio at the end of the remote startsequence.These would be off the Idatalink module.

-------------
Cris




Posted By: bruc007
Date Posted: January 30, 2008 at 7:02 PM
it does have the idatalink.so that also looks after the tach ..neat
Thanks




Posted By: StealthEs
Date Posted: January 30, 2008 at 7:03 PM
Yes then you should be set. I would also have the tach wire from the module just in case.

-------------
Cris





Print Page | Close Window