Print Page | Close Window

first time installing remote start alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10175
Printed Date: July 20, 2025 at 7:52 AM


Topic: first time installing remote start alarm

Posted By: mikeknerr
Subject: first time installing remote start alarm
Date Posted: February 27, 2003 at 7:35 PM

When the car is in park, the neutral saftey switch reads ground. 

 When the car is in gear should the neutral safety switch register 12 volts?




Replies:

Posted By: Two_Cold
Date Posted: February 27, 2003 at 9:54 PM
Reverse polarity is not common on a neutral safety switch. What kind of car?



Posted By: mikeknerr
Date Posted: February 28, 2003 at 5:57 AM

I was reading the manual and it said that the safety switch would would negative ground when in park or neutral.

I was just curious to know before I started if it would read positive when in gear.

The car is a 1995 Suburban.




Posted By: jrilla
Date Posted: February 28, 2003 at 3:55 PM
Just try to start the car in gear, if it doesnt start then dont worry about it. If it does start in gear then worry. Also make sure that you cant take the key out unless the car is in park.

-------------
J Rilla

Owner/Installer


Print Page | Close Window