08 lucerne dome light.
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101771
Printed Date: May 09, 2024 at 10:13 PM
Topic: 08 lucerne dome light.
Posted By: kaczarcollision
Subject: 08 lucerne dome light.
Date Posted: February 01, 2008 at 12:36 PM
after install of the r.s. i have no domelight control from the switch on the dash(dimmer) or when the doors open. i am not tied into that circuit as far as i know. it works when you press each light manually on the ceiling. any ideas would be great.
-------------
disturbing the peace since 1984
Replies:
Posted By: hydroz_23
Date Posted: February 01, 2008 at 5:48 PM
did you try to open and close all doors and cycle the ignition?
Posted By: kaczarcollision
Date Posted: February 02, 2008 at 3:23 PM
is there a sequence for cycling the ign. or just on off a few times? i have probably 20 hours in diagnostics. with more that one brain involved. right now it as the dealer for a bcm reflash.
-------------
disturbing the peace since 1984
Posted By: sparkie
Date Posted: February 02, 2008 at 3:35 PM
Check fuse # 32 and #35 in the rear fuse box under the rear seat. You could have also created a logic lock in the BCM. Disconnect the negative battery cable for a minute and then try again. The lights get 12 volts + on the gray/black wires from the BCM. It comes out of the pink plug of the BCM. Check the pins in the BCM if you unpluged it for a bent pin.
-------------
sparky
Posted By: mobile1
Date Posted: February 02, 2008 at 5:49 PM
I'm going to ask a really dumb question so don't take offense, but is everything plugged in? I know its common sense, but i had a Highlander come back because the heater wasn't functioning properly, and come to find out, I was a pet monkey and forgot to plug a sensor back in. I just want to start with the basics :)
|