2003 altima remote start won’t start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101786
Printed Date: April 28, 2024 at 4:10 AM
Topic: 2003 altima remote start won’t start
Posted By: yasavant
Subject: 2003 altima remote start won’t start
Date Posted: February 01, 2008 at 11:15 PM
Doing an install for a friend on a 2003 altima 2.5.I have everything wired properly. but the car will not start he bought the car used and it came with an ilco transponder key copied of course. So he had another copy made to put into the bypass. Everything works fine but when I try to start the car will crank and engage the starter but the engine will not start at all.Could the key be the problem?
-------------
SS
Replies:
Posted By: prdjr165
Date Posted: February 01, 2008 at 11:26 PM
try putting the key (a key that starts the car)in the ignition switch and try to remote start the car.That will tell you if it's your remote start or a bypasss issue.
Posted By: flobee4
Date Posted: February 01, 2008 at 11:44 PM
Nissan Keys need to be programmed by the dealers service dept. Its a good idea to bring ALL the keys he has plus the new one to the dealer for programming. There is another alternative though, you can get a keyless bypass like these: https://www.ifar.ca/products/all_products/key-override-all/ or https://www.bypasskit.com/product.aspx?prodid=PKN2 or https://www.idatalink.com/store/index.php?l=product_detail&p=7
Posted By: flobee4
Date Posted: February 01, 2008 at 11:46 PM
sorry, forgot to mention that all those keyless bypasses do NOT need the dealer, just one working key. Frank
Posted By: yasavant
Date Posted: February 03, 2008 at 9:58 PM
I will give it a try this week when my friend is availiable, thanks for the info people.  ------------- SS
Posted By: turboneon
Date Posted: February 03, 2008 at 10:03 PM
Also double check that you have all the ignition wires powered up.
Posted By: yasavant
Date Posted: February 06, 2008 at 5:57 PM
the dam thing still won't start. I think the car thinks it is being stolen so it locks everything up. when i remote start the car,starter engages but it will not start (immobilized) but while the remote start is cranking I turn the key(without transponder) to start it will start. So I know it is not a bypass issue. because it is getting the signal. And also when I start the car with the transponder key and shut it down, I can use the remote starter to start the car within 3 seconds I shut the car off. I didn't use any relays or diode isolate anything was I suppose to?
-------------
SS
Posted By: techman93
Date Posted: February 06, 2008 at 7:37 PM
Make sure you check all ignition wires to see if they are getting powered properly and that you don't have the accessory wire to an ignition and that you don't have second accessory hooked up instead of ignition.
-------------
The wire I'm test'n isn't doin' what it's supposed to be doin'... I am so glad I printed that tech sheet, with the wrong info.
Do it right the first time... or I might have to fix it for ya
Posted By: yasavant
Date Posted: February 08, 2008 at 8:11 PM
Could it be the 2nd starter wire? I didn't make any connections or relays to it except for trying to jump it from the starter output from RS. This did work on prior nissans. Maybe I should hook up a relay to silate the 2nd starter wire. Where would the connections be made?
-------------
SS
Posted By: tedmond
Date Posted: February 08, 2008 at 10:05 PM
isolate each starter wire, its done by the company for a reason. 85 - constant 12v
86 - negative output for additional START (-) 250 mA
87 - constant 12v
30 - second starter wire on car.
Posted By: yasavant
Date Posted: February 09, 2008 at 2:51 PM
Yes it was the second starter wire thanks for you help. Very much appreciated. Anyone reading this post nissan cars is a must in hooking up relay to power 2nd starter wire. Thanks for everyones help.
-------------
SS
|