Print Page | Close Window

driver settings with aftermarket remote

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101807
Printed Date: May 04, 2025 at 4:09 PM


Topic: driver settings with aftermarket remote

Posted By: trailblazzin
Subject: driver settings with aftermarket remote
Date Posted: February 02, 2008 at 3:00 PM

i currently have a viper 5900 r/s hooked up using the gmsl-2 and gm-9 t-harness to my 2003 Chevrolet Trailblazer.  My only problem is that when I use the viper keyfob sometimes it says "Driver 1", and sometimes it says "Driver 2". I reprogrammed just one of my factory remotes so it would think there is just one driver. I want all the settings to stay the same and i am the only driver, but if i change the heat and the next time i get in it has switched to the other driver it will be where it was the last time i was in with that settings.

if you have any idea's how to fix this please let me know.....




Replies:

Posted By: trailblazzin
Date Posted: February 03, 2008 at 1:30 PM
also..... i forgot to mention that sometimes with my viper remote it will not unlock all the doors on the first unlock.... acts like driver priority, wich i don't have setup.  but other times it will unlock them all.


Print Page | Close Window