08 tundra remote start

Looking for this diagram, none here yet and I have one booked on friday.

Thanks

Doorlocks/Windows       

Power Unlock RED (-) IN HARNESS IN DRIVERS KICKPANEL
PowerLock WHITE (-) IN HARNESS IN DRIVERS KICKPANEL
Driver Mtr Unlock BLUE/WHITE (+) IN HARNESS IN DRIVERS KICKPANEL
Driver Mtr Lock BLACK / YELLOW (+) IN HARNESS IN DRIVERS KICKPANEL
LF Window Up RED (REV) AT WINDOW SWITCH IN DRIVER DOOR
LF Window Dn GREEN (REV) AT WINDOW SWITCH IN DRIVER DOOR
RF Window Up RED (REV) AT WINDOW SWITCH IN PASSENGER DOOR
RF Window Dn GREEN (REV) AT WINDOW SWITCH IN PASSENGER DOOR

Remote Start       

Battery WHITE (+) IGNITION SWITCH HARNESS
Ignition 1 BLACK (+) IGNITION SWITCH HARNESS
Ignition 2 LIGHT GREEN (+) IGNITION SWITCH HARNESS
Accessory 1 GRAY (+) IGNITION SWITCH HARNESS
Starter 1 DARK GREEN (+) IGNITION SWITCH HARNESS
Anti-Theft Type UNIVERSAL IMMOBILIZER
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense GRAY OR LIGHT GREEN (-) IGNITION SWITCH HARNESS   
   AT BODY ELECTRONIC CONTROL MODULE IN DRIVER KICKPANEL, WIRE IS LIGHT GREEN AT BODY ELECTRONIC CONTROL MODULE
Tachometer WHITE (AC) AT DATA LINK CONNECTOR
   DATA LINK CONNECTOR IS LOCATED UNDER DASH ON DRIVER SIDE
Speed Sense YELLOW (AC) AT SKID CONTROL ECU AT BRAKE BOOSTER
Parking Lights GREEN (+) IN PLUG ON BOTTOM OF FUSE BOX
Brake Lights ORANGE (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Lights RED / BLACK (+) IN HARNESS IN DRIVERS KICKPANEL
Horn ORANGE (-) IN HARNESS AT STEERING COLUMN

Thanks man !

I didnt see a listing up there for arm/disarm...they are found in the drivers kick panel in a blue plug, the harness coming from the drivers door.  Pink for arm, will also control the door locks.  Disarm is blue, first pulse disarms and unlocks drivers door, 2nd pulse unlocks all doors.   To disarm without unlocking hook up keysense (grey) at ignition switch.  The arm/disarm wires are they VERY small wires in that blue plug...

good tip, quick too

thanks again guys

just be aware that most of your wires will be 24awg or smaller. you cannot use power at the ignition harness, use the large black wire going into the fuse panel.

-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta

I'm doing my 07 tundra now, the arm and disarm are in the same harness with the power door locks. They are
Arm with Lock (-) Lt. Blue - DKP
Disarm with Unlock (-) Pink - DKP
* Use these wires to make your factory alarm work side-by-side with your aftermarket unit.

I also tapped into the factory gbs sensor module and found the output in which i tied into my my aftermarket alarm.

-------------
If it's not custom, then it's not you.

I also ran a 10 guage amp kit for the remote start acc wires from the fuse box under the hood. First toyota ive seen with 20 guage or smaller wire in the igntion.

-------------
If it's not custom, then it's not you.

I always use the fat black wire on the front of the fuse box....

-------------
Mike M2
Tech Manager
CS Dealer Services

Hey I have the PKT2 module to bypass the immobilizer, when you get yours done can you me so insight on it. Thanks

-------------
If it's not custom, then it's not you.