06 mazda3 manual trans r/s
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101904
Printed Date: May 03, 2024 at 8:41 AM
Topic: 06 mazda3 manual trans r/s
Posted By: sleeper1104
Subject: 06 mazda3 manual trans r/s
Date Posted: February 05, 2008 at 1:35 PM
Love the forum here, searched but found mixed results. Installed an astrostart rs613 on this car but cannot get it to start remotely. Theft indicator will just flash when i attempt it. If i shut down the car in the saftey sequence it will stay running after keys removed so i'm assuming the bypass is working, so i think i have a clutch bypass issue.
Some results here say hook starter wire to gray/black in drivers kick, as does astrostarts instructions, tried that. Other posts say send (-) to grey/black and also hook starter wire to crank wire at ign harness.
Can anyone confirm how to do this? I won't have the car back for a couple days or i would just try.
Thanks
Replies:
Posted By: extreme1
Date Posted: February 05, 2008 at 1:44 PM
your bypass isn't working
------------- Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: sleeper1104
Date Posted: February 05, 2008 at 1:49 PM
I'll check into that, when i hooked it up the papers with it said if it was flashing at the same time as the theft indicator it was properly setup. When i try a remote start i get a rapid flash out of the dash indicator. Thanks for the quick response!
Posted By: perly
Date Posted: February 05, 2008 at 3:12 PM
sounds like 100% the bypass. what bypass did you use?
Posted By: extreme1
Date Posted: February 05, 2008 at 6:23 PM
sleeper1104 wrote:
I'll check into that, when i hooked it up the papers with it said if it was flashing at the same time as the theft indicator it was properly setup. When i try a remote start i get a rapid flash out of the dash indicator. Thanks for the quick response!
did you program the bypass to your vehicle? ------------- Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
|