ultrastarter

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=101944
Printed Date: May 13, 2024 at 7:10 AM

Topic: ultrastarter

Posted By: daku604
Subject: ultrastarter
Date Posted: February 06, 2008 at 11:37 AM

Hi, i'm a newbie here...... I did some searches on the install but still unsure of where to get the + 12 supply for the start/alarm. There are two + 12v wires fused at 30A each... Some say to tie them together and tap into ign. wire..... will this be ok to do on a 90 integra????

Replies:

Posted By: Twelvoltz
Date Posted: February 06, 2008 at 1:17 PM

Yes you can use the constant hot feeds in the ignition harness to power your Ultrastarter system on a 90 Integra. Any time you are in doubt though the battery itself is the best place to get constant hot supplies.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: daku604
Date Posted: February 06, 2008 at 1:32 PM

Thanks for the info.......

Posted By: pbrian37
Date Posted: February 06, 2008 at 1:39 PM

I wouldn't waste time on the battery with such an old ignition system, plenty of power

Print Page | Close Window