07 toyota tundra window

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=102099
Printed Date: May 15, 2024 at 4:21 AM

Topic: 07 toyota tundra window

Posted By: keysersoza
Subject: 07 toyota tundra window
Date Posted: February 11, 2008 at 5:13 PM

Please help trying to install Scytek window roll up in 07 Tundra Dual Cab Using Scytek window roll up module. Looking for wire colors and location and any pointers to make this just easier. Thanks

Replies:

Posted By: StealthEs
Date Posted: February 11, 2008 at 5:20 PM

Left Front Window (Up/Down)	lt. green - lt. blue	A	driver window switch in door
Right Front Window (Up/Down)	yellow - green	A	driver kick, blu 10P plug, pins 9, 8
Left Rear Window (Up/Down)	purple to red - black to org	A	driver kick, blu 10P plug, pins 6, 7
Right Rear Window (Up/Down)	orange - lt. green	A	driver kick, blu 17P plug, pins 5, 4
Sun Roof (Open/Close)	N/A
Sun Roof (Limit/Close)	N/A
Memory Seat 1	pink	-	seat memory switch in door
Memory Seat 2	orange	-	seat memory switch in door
Memory Seat 3	N/A

-------------
Cris

Posted By: StealthEs
Date Posted: February 11, 2008 at 5:23 PM

dual cabs are different heres what I have for the dual cab

Left Front Window (Up/Down)

red - green

LF window switch in door

Right Front Window (Up/Down)

red - green

RF window switch in door

Left Rear Window (Up/Down)

red - green

LR window switch in door

Right Rear Window (Up/Down)

red - green

RR window switch in door

The back power window wires are red (up) and green (down) at the relay or motor on the passenger side rear cabin wall.

Sun Roof (Open/Close)

motor part of module

-------------
Cris

Posted By: keysersoza
Date Posted: February 11, 2008 at 5:44 PM

Can You tell me which way is the switch side on the colors on the plug and which way is motor side.

Posted By: StealthEs
Date Posted: February 11, 2008 at 6:02 PM

cut the wire in half, hook up a MM to one side and hit the switch. When you connect to the side the shows voltage thats the switch side the other it the motor side.

-------------
Cris