2007 scion tc activation input

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=102218
Printed Date: May 15, 2025 at 11:59 AM

Topic: 2007 scion tc activation input

Posted By: wsc75
Subject: 2007 scion tc activation input
Date Posted: February 15, 2008 at 4:53 AM

Hi everyone, Im installing a vallet 561t into an '07 Scion tC. What can I use to remote start the car? The customer wants to use her factory key pad and Im not sure where to connect these wires to. Theres a WHITE/ Blue(-) and a WHITE/ Red(+) thanks.

Replies:

Posted By: wsc75
Date Posted: February 15, 2008 at 5:31 AM

She wants to use her unlock button 3 times to R/S her car. Also when I tap the WHITE/ Blue wire to ground twice the ignition comes on but then shuts off immediately. Any ideas as to what this can be? I did shutdown diagnostics and it flashes 6 six times i think it was, which means (-) shutdown. Thanks

Posted By: wsc75
Date Posted: February 15, 2008 at 3:42 PM

Ok, I got the activation input wire hooked up to the unlock motor. Now whenever I try to r/s it it doesn't work and shutdown diagnostics still says (-) shutdown. I'm stumped.

Posted By: chadwa2003
Date Posted: February 15, 2008 at 4:30 PM

Check your hoodpin wire

Posted By: tedmond
Date Posted: February 16, 2008 at 10:38 PM

hood pin or check for Ebrake connection. the unit if it requires one,just ground that wire.

Print Page | Close Window