Print Page | Close Window

2003 matrix window down need fix

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=102273
Printed Date: May 16, 2025 at 8:43 AM


Topic: 2003 matrix window down need fix

Posted By: 78musicman
Subject: 2003 matrix window down need fix
Date Posted: February 17, 2008 at 8:53 AM

have a 2003 matrix the drivers master switch is bad.The passenger window is down.If i pull the pass door panel off what is the polarity or pulse i need to send to the window motor to get it up?What colors need help fast please.THANKS

-------------
colorado tap the rockies



Replies:

Posted By: flobee4
Date Posted: February 17, 2008 at 9:09 AM

You need to disconnect the harness that clips in at the window motor first.  You cannot just tap into the wires, the rest at ground.  If you try to apply voltage to the wires you will be creating a short. So,  after you disconnect the harness, there should be only 2 contacts at the motor.  apply 12v to one contact and ground to the other.  if the window doesn't go up then reverse your 12V and Ground.  One way makes the window go up, the other makes the window go down.  If you try it both ways and the window doesn't move and you are definitely giving it power, then your window motor is shot.

Also, if you cannot get to the power window connection at the motor, you can cut the two wires in halve.  You'll use the motor side of the wires you cut. At the end just put the wires back together.

Good luck,

Frank




Posted By: 78musicman
Date Posted: February 17, 2008 at 9:59 AM
thanks fixed

-------------
colorado tap the rockies


Print Page | Close Window