Printer Friendly Forum Posts - ford gold programing options

Factory Option Bank 1 – 4 chirps default
1 – Lite-touch adjustment
2 – Full shock adjustment
3 – Optional alarm disable
Disables security functionality............. Off
4 – Passive starter Interrupt
Starter interrupt activates 1 minutes after key off event. ................................ Off
5 – Passive arming
Security system activates 1 minutes after key off event. ................................ Off
6 – Passive door locks
All doors lock automatically 1 minutes after key off event. ............................... Off
7 – Selectable chirps
Enables arming/disarming confirmation chirps (uses horn). .............................. On
8 – Silent choice
On – Confirmation chirp on second press of transmitter button
Off – Confirmation chirp on first press of transmitter button.
Requires option #7 (above) to be ON. ....................................... On

Factory setting Option Bank 2 – 5 chirps
1 – Drivers door priority unlock
Drivers door only unlocks on first press of Disarm/Unlock,
All doors unlock on second press within 5 seconds. ................................. Off
2 – Ignition lock
All doors lock when ignition key is turned to on (run). ................................... Off
3 – Ignition unlock
All doors are unlocked when ignition key is turned to off. ..................................... Off
4 – Delayed door lock for ignition lock
Waits 3 seconds after key on event before activating ignition lock.
Used on vehicles with theater dimming interior lights. ................................. Off
5 – Illuminated exit
Activates dome light output for one minute when ignition key is turned off ....................................... On
6 – Horn used for alarm
Horn sounds during alarm/panic cycles .................................... On
7 – Noise control
Limits alarm trips to 5 per zone ...................................... On
8 – Factory RKE system does not arm alarm
Prevents factory RKE from arming security system. Still allows
factory RKE to disarm security system. .................................. Off
Factory setting

Option Bank 3 – 6 chirps
1 – Tach diagnostic mode
This feature should only be used for troubleshooting purposes only!
Car start function ignores tach input and cranks starter one time for one second.
WARNING – Over rev and stall detection is disabled when this option is enabled. .................................. Off
2 – Car start run time
LED On – 15 minutes, LED Off – 10 minutes ................................... Off
3 – Lock after start
(Re)locks doors after remote start. .................................... Off
4 – One button start
Activates remote start by press and hold of start button. ................................... Off
5 – Diesel timer
Delays crank attempt 30 seconds after ignition on. ....................................... Off
6 – Rear Defrost output activation
LED On- Activation only after remote start, LED Off- Activation anytime .................................... On

Option Bank 4 – 7 chirps
1 – Headlight Output Time (used only when option #5 below is in the LED Off position)*
LED On – 20 seconds, LED Off – .5 seconds .................................... On (20 sec.)
2 – Rear Defrost Output Time
LED On – 10 minutes, LED Off – .5 seconds ............................... Off (.5 sec.)
3 – Auxilliary Output Time
LED On – .5 seconds, LED Off – Time held ................................... On (.5 sec.)
4 – Power Sliding Door Output Time (used only when option #5 below is in the LED On position)*
LED On – .5 seconds, LED Off – Time held ................................... On (.5 sec.)
5 – Convert headlight output to act as the power sliding door output .....................................
(controlled by pressing Find/Panic and Start buttons simultaneously)
LED On- Power Sliding Door Output, LED Off- Headlight Output ................................. Off
* The Headlight Output and Power Sliding Door Output both use the C-10 RED / White wire

RKE/VSS/RMST OPTION CHART (Cont’t)

Option Bank 5 – 8 chirps
1 – Door ajar switch input polarity
LED On – Positive, LED Off – Negative ........................ On (Positive)
2 – Unlock switch sense input polarity
LED On – Positive, LED Off – Negative ........................ On (Positive)
3 – Key-in sense input polarity
LED On – Positive, LED Off – Negative ........................ Off (Negative)
4 – Door Ajar Input Entry Delay
5 Second entry delay. Used for vehicles with external door mounted RKE keypads ................................. Off
5 – Use trunk relay as Driver door unlock
Switches Trunk release and Drivers door unlock outputs ................................. Off
6 – Learn tachometer
With hood open or brake pedal pressed start engine. System will chirp horn
every five seconds if a valid tach signal is present.

-------------
If i Can't Install it I Don't need it Joe