529t controlled duration with 562t

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=103028
Printed Date: June 11, 2024 at 1:05 AM

Topic: 529t controlled duration with 562t

Posted By: tjetzer
Subject: 529t controlled duration with 562t
Date Posted: March 13, 2008 at 11:47 AM

Is it possible to do controlled duration in both directions (One motor, up and down) with a 562T remote start? If so, which wires off the 562T would be used?

Thanks

Replies:

Posted By: howie ll
Date Posted: March 13, 2008 at 1:11 PM

Just looked on directechs couldn't find a 562t what brand is it ? Viper Hornet etc? The leads you want on the 529t are the grey and grey /black

Posted By: howie ll
Date Posted: March 13, 2008 at 1:18 PM

Have you got a violet/black and WHITE/ black channel 4 & 5 outputs? You can use these to send window up and down. Look at 529t instructions, cut up feed and down feed to motor and follow the colours accordingly.

Posted By: tjetzer
Date Posted: March 13, 2008 at 2:26 PM

Howie,

Thanks for the reply. It's a Valet 562T. It does not have a 5th output, only a 4th.

Here is the real issue I'm having. The 529T is not going to be controlling a window, it will be controlling the power trim on a boat. The only real change in resistance/current draw would be when the tim hits a certain point and changes from a fast ascent/descent to a slow ascent/descent. I would prefer the controlled duration so the trim can be controlled at all times rather than have full up/down.

Do you have any suggestions?

Posted By: howie ll
Date Posted: March 13, 2008 at 2:58 PM

orry I jumped in before, ignore the grey and grey/black, use orange and and orange back, are you using the the red white on the 562t?

Posted By: tjetzer
Date Posted: March 13, 2008 at 4:22 PM

I haven't installed anything yet. The red black wire will not be used for anything. I assume that wire is controlled by the "AUX" on the remote, then I could use the Channel 4 wire for the other validity channel. This would then give me controlled duration, correct?