python 880 led’s stay on

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=103195
Printed Date: May 10, 2025 at 4:41 AM

Topic: python 880 led’s stay on

Posted By: jonyb
Subject: python 880 led’s stay on
Date Posted: March 18, 2008 at 8:52 PM

I recently removed the Pioneer D3 and a few other things from my truck. When I completed removing that stuff, the LED's from the Python 880 alarm came on and will not go off. I've put it in and out of valet mode and the LED's never went off, so it's not in valet mode. It's been like this for a week and for the life of me I can't figure it out. There's nothing in the trouble shooting guide about this. Any idea's?

Replies:

Posted By: draasch
Date Posted: March 18, 2008 at 9:20 PM

are the valet wires pinched??

-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt

Posted By: skee-weezy
Date Posted: March 18, 2008 at 9:22 PM

if all other functions of the system appear normal... u might have a defective led output on the system.. or a bad led...... not a big deal.... u could wire up another led... like a street glow or something or one from radio shack to the orange ground while armed, and of course constant and turn on.... the orange will be the trigger when the system is armed... it will do the same thing.......

-------------
there can be only one.......

Posted By: jonyb
Date Posted: March 18, 2008 at 9:26 PM

Valet switch wires shouldn't be pinched because the switch worked fine.

There are 3 LED's that are all tied together. I didn't think of plugging in another one, I'll try that.

Posted By: techman93
Date Posted: March 18, 2008 at 10:38 PM

normally there are not 3 leds off of one output on DEI pieces.

-------------
The wire I'm test'n isn't doin' what it's supposed to be doin'... I am so glad I printed that tech sheet, with the wrong info.
Do it right the first time... or I might have to fix it for ya

Print Page | Close Window